Your SlideShare is downloading. ×
  • Like
  • Save
sE Electronics R1
Upcoming SlideShare
Loading in...5
×

Thanks for flagging this SlideShare!

Oops! An error has occurred.

×

Now you can save presentations on your phone or tablet

Available for both IPhone and Android

Text the download link to your phone

Standard text messaging rates apply
Published

sE Electronics R1 …

sE Electronics R1
Visit us at - http://www.themusicespionage.co.uk/

Published in Education
  • Full Name Full Name Comment goes here.
    Are you sure you want to
    Your message goes here
    Be the first to comment
    Be the first to like this
No Downloads

Views

Total Views
529
On SlideShare
0
From Embeds
0
Number of Embeds
2

Actions

Shares
Downloads
0
Comments
0
Likes
0

Embeds 0

No embeds

Report content

Flagged as inappropriate Flag as inappropriate
Flag as inappropriate

Select your reason for flagging this presentation as inappropriate.

Cancel
    No notes for slide

Transcript

  • 1. sE Electronics www.seelectronics.comRT1 – Technical InformationThe sE R1-Ribbon is a beautiful piece of engineering. It’s single ‘Figure of 8’ polar pattern isderived from an incredibly fine 1.8 micron Aluminium membrane.As such the R1 has a higher-than-normal frequency roll-off (at around 7KHz), and greatersensitivity, producing a more open and natural sound than you’d expect from a ribbon mic.The R1 is ideally suited to most recording applications including electric guitar cabs,overhead drum micing, recording brass and woodwind instruments, strings and forcommercial broadcast and voice-over.The R1 is not so much a mic for specific applications but a mic that brings a differentsound for ALL your applications.The R1 is packaged in a tough, aluminium flightcase and comes complete with shockmount.Technical Specifications Electrodynamic pressure Acoustical operating principle Maximum SPL: >135dB gradient Dynamic range of the microphone Directional pattern: Figure-8 101(117)dB amplifier (A-weighted): 2.5-micron aluminum Generating Element: Powering : Power supply unit (PSU) ribbon Magnets: Rare Earth Neodymium Matching connectors: XLR3F Frequency range: 30 -15,000 Hz Weight: 465g Sensitivity at 1 kHz: 2.2mV/Pa Diameter: 40 mm Output Impedance: 300 Ohms @ 1K (nominal) Length: 166 mm Rated Load Impedance: >1500 Ohms @ 300 Ohms1) According to IEC 60268-1; CCIR-weighting acccording to CCIR 468-3, quasi peak; A-weighting according to IEC 61672-1, RMS2) Measured as equivalent el. input signalPolar pattern and Frequency Chart 0° 0 315° 45° dB -5 +10 -10200Hz -15 1KHz 0 -2020KHz 270° dB 90° -10 -20 20Hz 50 100 200 500 1K 2K 5K 10K 20K 225° 135° 180°