• Share
  • Email
  • Embed
  • Like
  • Save
  • Private Content
9300 programming
 

9300 programming

on

  • 306 views

 

Statistics

Views

Total Views
306
Views on SlideShare
306
Embed Views
0

Actions

Likes
0
Downloads
0
Comments
0

0 Embeds 0

No embeds

Accessibility

Categories

Upload Details

Uploaded via as Adobe PDF

Usage Rights

© All Rights Reserved

Report content

Flagged as inappropriate Flag as inappropriate
Flag as inappropriate

Select your reason for flagging this presentation as inappropriate.

Cancel
  • Full Name Full Name Comment goes here.
    Are you sure you want to
    Your message goes here
    Processing…
Post Comment
Edit your comment

    9300 programming 9300 programming Document Transcript

    • Standard Low Level Programming It is possible to change the parameters of the Equipment System by positioning specific jumpers located on the system board.Jumper Location Jumper 1 - Current Limiting Option Position 1 (High Current / 240vac): There is no current restriction. This allows the heater to operate with the pump (both pumps on a dual pump system) in high speed. Position 2 (Low Current / 120vac): The system will not turn the heater on when the pump is in high speed (one of the pumps on a dual pump system). The heater On indicator will flash on the display to tell the user that there is a call for heat but the heater is not allowed to start. Jumper 2 - Temperature Unit Position 1: Temperature will be displayed in Fahrenheit degrees. Position 2: Temperature will be displayed in Celsius degrees. Jumper 3 - Pump 1 Position 1: Two Speed Pump Position 2: Single Speed Pumps Jumper 4 - Pump 2 Position 1: Two Speed Pump Position 2: Single Speed Pumps http://www.MyPoolSpas.com Wholesale Pool and Spa Parts 920-925-3094