Motion sensor LED tube 18w Motion sensor LED tube T8Description:Motion sensor LED is an intelligentLED tube that can be automaticallydimmable by inducting the thermalradiation from body or the car inorder to save more energy, and iswidely used for underground parking,warehouse, tunnel lighting and otherplaces.Specification:Input voltage AC85~265/50~60HZRated power 18wattsMin power 3wattsColor temperature 5500-6500k(frosted cover)Cover type Frosted/clear/stripeBase type G13 medium Bi-pinDimension D26*L1200mmLuminous flux 1650lm(frosted cover)Inductive beam angle 120°Inductive distance 6~10metersInductive overtime 25~30s(factory set)Reaction time 0.5sPower factor 0.95Work temperature -20℃~55℃Remark:Inductive overtime can be customized according to your requirements.
How it works?When the car or a person enters in the sensor area, the infrared LED tube will be full light, the power willbe 18watts,then,lasting lighting for 30seconds,then,becoming dark, and the power will be 3watts afterthe motion is from the sensor area.Remark: motion sensor led tube is not workable in the fixture with Cover. (workable) (unworkable)
Installation guideWarning: risk of electric shock! Ensure that the power supply is off when wiring sectionsof this device. This device is to be installed by a qualified electrician or technician inaccordance with all relevant local codes. Please read this user guide completely prior toinstallation and please pre-plan the installation.Note: please remove Bi-pin shipping protectors from end of tubes prior to installationUnpacking1. Unpack and carefully examine the product2. Report any damage and save all packing materials if any part is damaged during transport3. Do not attempt to use this apparatus if it is damagedBefore you start: Installation of your new LED tube is simple, but requires a basic knowledge ofwiring (as shown below).if you do not feel comfortable with this type of wiring, Okuhlaza Energywould recommend consulting a qualified electrician.Note: please ensure that power is disconnected from fitting before installing LED tubeWiring with Magnetic ballastFor a single tube, the magnetic ballasts do not need to be removed, if the installation has multipletubes, then the ballast must be removed, to maximum energy saving, it is recommended to alwaysremove the ballast, the preheat/starter lamp should be removed when used with an LED tube
Wiring with Electronic BallastYou should not use an LED tube with electronic ballast. Remove or bypass the electronic ballast priorto installation, to avoid damage to the LED tube.