MIX 1 screen shots

242 views
182 views

Published on

LO4 Audio Production

0 Comments
0 Likes
Statistics
Notes
  • Be the first to comment

  • Be the first to like this

No Downloads
Views
Total views
242
On SlideShare
0
From Embeds
0
Number of Embeds
69
Actions
Shares
0
Downloads
2
Comments
0
Likes
0
Embeds 0
No embeds

No notes for slide

MIX 1 screen shots

  1. 1. At the beginning of the song the guitar is to over powering compared to the other sections so Iadded distortion to quieten it a bit.This microphone of the recording this picks up the sounds from around the room, I prefer thesounds from the individual instruments so I have used distortion to completely get rid of the soundfrom this recording point.
  2. 2. I adjusted some of the levels for the snare as I felt it needed to be a little louder so raised a few ofthe levels but to make sure it was more of a distinct sound I added a gate only allowing a certainsection through so that sounds when the drum is not being hit is cut out.I did the same for the kick drum as I feel that they should be made out clearer, the gap between thebeat of the snare is the kick drum so these need to be empahsised and make sure that the drums areheard clearly, I also adjusted the volume on the mixer to make them louder.
  3. 3. For the bass this is constant throughout I mixed these together as they were easy to single out as 09Shadows 08, I adjusted the EQ for the bass Amp 09 so that it was a bit louder and then adjusted thelevels of the mixer so that they were louder aswell.I adjusted all the levels so that the instruments did not over power the vocals, the mixer volumeswere adjusted to fit the song.

×