The-Communication-System-Is-Changing-Drastically-A107

266 views

Published on

0 Comments
0 Likes
Statistics
Notes
  • Be the first to comment

  • Be the first to like this

No Downloads
Views
Total views
266
On SlideShare
0
From Embeds
0
Number of Embeds
1
Actions
Shares
0
Downloads
2
Comments
0
Likes
0
Embeds 0
No embeds

No notes for slide

The-Communication-System-Is-Changing-Drastically-A107

  1. 1. The communication system is changing drastically and there is a need for a safe communicationsystem especially for easy and economical satellite earth station antennas that normally range from a sub meter to usually 5 meters in diameter.dipole antennas
  2. 2. Care should be taken while selecting the Earth Station Antennasand must check these earth station antennas against risk of damageor any kind of destruction whether natural or an artificial destructionTherefore, in this article we shall learn about the precautions and thesecurity measures that we should adopt in case of earth stationantennas and also understand the how to install Antenna ControlUnit
  3. 3. The earth station antennas that are mounted groundcommunication equipment are most probable to risks This dipoleantennas is because the earth station antennas that are mounted onthe ground or on plains have to face the natural damages in the formof strong winds or may be any type of intentional man made attack
  4. 4. Now, talking about the Antenna Control Unit, the Antenna ControlUnit must be installed below the decks in such a way that its positionshould have good ventilation; it should be dry and should have aneasy access Basically, the Antenna Control Unit (ACU) is usuallyinstalled with the help of two fixing brackets supplied
  5. 5. The following are the steps that must be followed while installingthe Antenna Control Unit (ACU) * First of all, the installation sitemust be found out keeping in mind the desired objectives
  6. 6. * With the help of the screws, the mounting brackets are fixed to thesides of the Antenna Control Unit * The next step is place to theAntenna Control Unit in the same position where it has to be installed
  7. 7. * Now, the cables are connected to the rear of the Antenna ControlUnit * With the help of a pencil mark the four hole positions, with twoholes on each side for fixing the mounting brackets
  8. 8. * Drill the four holes as marked earlier Finally, fix the AntennaControl Unit with the help of the screws
  9. 9. dipole antennas

×