Vacuum system can be mounted on rear of unit.

Vacuum system can be mounted on rear of unit.

Floating head (shown in center position) can be used on right hand and left hand of machine

Floating head (shown in center position) can be used

on right hand and left hand of machine

Operator can see work area easier.

Operator can see work area easier.

Floating head can hold up to 13” wide blade set.

Floating head can hold up to 13” wide blade set.

Toolcat makes an excellent unit for the floating head.

Toolcat makes an excellent unit for the floating head.

Floating Head Rider Saw with vacuum proven productivity.

Built strong for a long service life.

8” wide Floating Head show with a 5” extender. Up to 13” total width. Manual adjusters optional.

8” wide Floating Head show with a 5” extender.

Up to 13” total width. Manual adjusters optional.

Plunge cut unit for marker installation fits any skid steer or can be truck mounted.

Plunge cut unit for marker installation fits

any skid steer or can be truck mounted.

Cutting head can be installed on right or left hand side with 5 minute change over.

Cutting head can be installed on right or left hand side

with 5 minute change over.

Cutting head is self-leveling. Conforms to the road surface.

Cutting head is self-leveling.

Conforms to the road surface.

Dust box remains at road level while cutting head goes down and up.

Dust box remains at road level

while cutting head goes down and up.

Operator can see work area.

Positive stop. Once you set your stop, you can never cut too deep or not deep enough.

Disconnects completely from the machine in less than 3 minutes.