Diagram for the Implementation of the EN 81-1/2:1998+A3:2009 (UCM) Standards in our Products.
Upcoming SlideShare
Loading in...5
×
 

Like this? Share it with your network

Share

Diagram for the Implementation of the EN 81-1/2:1998+A3:2009 (UCM) Standards in our Products.

on

  • 1,029 views

In view of the numerous doubts and queries from you, concerning the compliance with Standards: EN 81-1:1998+A3:2009 and EN 81-2:1998+A3:2009, we have produced a diagram in order to explain the ...

In view of the numerous doubts and queries from you, concerning the compliance with Standards: EN 81-1:1998+A3:2009 and EN 81-2:1998+A3:2009, we have produced a diagram in order to explain the processes relating to our products.

This is an explanatory diagram that is constantly updated. As soon as there are any modifications in it, you will be informed by this same channel. We hope this information may be of use and help to you.

http://dynatech-elevation.com/pub/documentos/documentos_cuadro_UCM_v01_ingles_2abea81a.pdf

Statistics

Views

Total Views
1,029
Views on SlideShare
1,028
Embed Views
1

Actions

Likes
0
Downloads
1
Comments
0

1 Embed 1

https://twitter.com 1

Accessibility

Categories

Upload Details

Uploaded via as Adobe PDF

Usage Rights

© All Rights Reserved

Report content

Flagged as inappropriate Flag as inappropriate
Flag as inappropriate

Select your reason for flagging this presentation as inappropriate.

Cancel
  • Full Name Full Name Comment goes here.
    Are you sure you want to
    Your message goes here
    Processing…
Post Comment
Edit your comment

Diagram for the Implementation of the EN 81-1/2:1998+A3:2009 (UCM) Standards in our Products. Presentation Transcript

  • 1. In the process to be  Per Unit certified  The customer has a unit certified as  UCM and does not need to check the  In the process to be  requirements requested in the A3 at  certified his/her installation  Governors    Safety Elements  Per Component + The customer makes the UCM A3 Requirements:  Safety gear solutions according to his/her  Item 9.11 of EN81‐ needs; however he/she must  +  1:1998+A3:2009  be held responsible for  checking that the unit meets  Dynatech Steering  ‐ car stop must be  the A3 requirements in his/her  Mechanisms  caused without  + installation exceeding 1.20 m ‐ ascending deceleration  of 1 g must not be  allowed and the values  accepted for the safety  gears must be allowed  in descending  deceleration   Control System  Controller  To be certified by the controller Tornado + Dynatech  control System (CDC‐060    and BFS‐059)  Drive Machine  Tornado + Controller  To be certified by the  operator