Presented By: Conrad Brown

cbrown@radnetworx.com
http://www.lokisec.com
http://twitter.com/guardrad
Founder of Lokisec.com and Southern Maryland
Hacker Space
Alphabet Soup
A+, Net+, Sec+, MCSE 2003, MCITP, CEH, ECSA
In the broad sense, physical computing is a creative framework
for understanding human beings' relationship to the digital...
An Open Source Physical Computing Platform
It is a simple input/output board with a
development environment.
Code on the Arduino IDE
Upload that code to the Arduino Board
Watch the Arduino Board run the code
int ledPin = 13;

// LED connected to digital pin 13

void setup()
{
pinMode(ledPin, OUTPUT);
}

// sets the digital pin a...
The Digital Pins use a digital signal. Digital
signals are either on or off.
The Analog Pins use an analog signal. Analog
...
Upcoming SlideShare
Loading in …5
×

Introduction to Physical Computing Using Arduino

250 views

Published on

Intro to Physical Computing class created for Southern Maryland Hackerspace.

Published in: Technology
0 Comments
0 Likes
Statistics
Notes
  • Be the first to comment

  • Be the first to like this

No Downloads
Views
Total views
250
On SlideShare
0
From Embeds
0
Number of Embeds
7
Actions
Shares
0
Downloads
6
Comments
0
Likes
0
Embeds 0
No embeds

No notes for slide

Introduction to Physical Computing Using Arduino

  1. 1. Presented By: Conrad Brown cbrown@radnetworx.com http://www.lokisec.com http://twitter.com/guardrad
  2. 2. Founder of Lokisec.com and Southern Maryland Hacker Space Alphabet Soup A+, Net+, Sec+, MCSE 2003, MCITP, CEH, ECSA
  3. 3. In the broad sense, physical computing is a creative framework for understanding human beings' relationship to the digital world. In practical use, the term most often describes handmade art, design or DIY hobby projects that use sensors and microcontrollers to translate analog input to a software system, and/or control electro-mechanical devices such as motors, servos, lighting or other hardware. Source: http://en.wikipedia.org/wiki/Physical_computing
  4. 4. An Open Source Physical Computing Platform It is a simple input/output board with a development environment.
  5. 5. Code on the Arduino IDE Upload that code to the Arduino Board Watch the Arduino Board run the code
  6. 6. int ledPin = 13; // LED connected to digital pin 13 void setup() { pinMode(ledPin, OUTPUT); } // sets the digital pin as output void loop() { digitalWrite(ledPin, HIGH); // sets the LED on delay(1000); // waits for a second digitalWrite(ledPin, LOW); // sets the LED off delay(1000); // waits for a second }
  7. 7. The Digital Pins use a digital signal. Digital signals are either on or off. The Analog Pins use an analog signal. Analog signals can vary and are not stuck to being either on or off.

×